Model |
DSO1062B |
Oscilloscope mode |
Bandwidth |
60MHz |
Real-time Sample Rate |
1GSa/s |
Equivalent Sample Rate |
25GSa/s |
Record Length(Sample Points) |
Single-channel: Maximum 1M; Dual-channel:Maximum 512k |
SEC/DIV Range |
2nS/div-2000S/div (in a 2, 4, 8 sequence) |
Delay Time Accuracy |
500ps |
Vertical |
A/D Converter |
8-bit resolution |
VOLTS/DIV Range |
2mV/div～5V/div at input BNC |
Position Range |
50V(5V/div),40V(2V/div～500mV/div),2V(200mV/div～50mV/div)400mV(20mV/div～2mV/div) |
Rise Time at BNC |
≤5.8ns |
DC Gain Accuracy |
4% for Sample or Average acquisition mode, 5mV/div to 2mV/div
3% for Sample or Average acquisition mode, 5V/div to 10mV/div |
Trigger |
Trigger Sensitivity
(Edge Trigger Type) |
DC: CH1/CH2(Typical) 1div from DC to 10MHz;1.5div from 10MHz to Full
AC: Attenuates signals below 10Hz
HF Reject: Attenuates signals above 80kHz
LF Reject: Attenuates signals below 150kHz
Noise Reject: Reduces trigger sensitivity |
Trigger Level Range |
CH1,CH2: 8 divisions from center of screen |
Trigger Level Accuracy,
typical (Accuracy is for signals having rise and fall times ≥20ns) |
CH1,CH2: (0.3divV/div) (within 4 divisions from center of screen)
|
Holdoff Range |
100ns-10s |
Trigger Type |
Edge |
Trigger on the rising or falling edge |
Pulse Width |
Trigger (when >,<,=,≠) on positive or negative pulses
Pulse Width Range: 20ns-10s |
Video |
Trigger on an NTSC, PAL, or SECAM standard video signal
Line Range: 1-525 (NTSC), 1-625 (PAL/SECAM) |
Slope |
Trigger (when >,<,=,≠) on a positive or negative slope
Set Time: 20ns10s |
Overtime |
from the rising or falling edge
Set Time: 20-10s |
Alternate |
Internal trigger on edge, pulse width, video or slope |
Measurement |
Cursors |
Manual: The difference between voltage cursors △V; the difference between time cursors △T; 1/△T calculated by Hz.
Tracing: The voltage and time at a waveform point |
Automatic |
Pk-Pk, Max, Min, Mean, Cyc RMS, Frequency, Period, Rise Time, Fall Time, Positive Width, Negative Width |
Meter Mode |
Max.Resolution |
6,000 Counts |
DMM Testing Modes |
Voltage, Current, Resistance, Capacitance,Diode & Continuity |
Max. Input Voltage |
AC: 600V, DC: 800V |
Max. Input Current |
AC: 10A, DC: 10A |
Input Impedance |
10 MΩ |
Display |
Type |
Right angle 5.6 16-digit color LCD |
Resolution |
640*480 dots |
Contrast |
16 gears, with the progress bar to show adjustment |
Interface |
USB host and USB slave, Lan Optional |
Power Supply |
Voltage |
DC Input:12--17VDC, 1500mA |
Mechanical |
Size |
245 x 163 x 52 (mm) |
Weight |
1.3KG (exclusive of packing and accessories) |
